TELEFIRE MCOM-7L

The TELEFIRE MCOM-7L is an advanced communication module that transmits data from TELEFIRE 7000 series fire alarm control panels to the cloud via various protocols. The module enables remote supervision, reporting, and maintenance, ensuring continuous monitoring of the fire alarm system and rapid response in emergency situations.

Key Features

Multiple Communication Protocols: The MCOM-7L supports three different communication modes:

• Cellular: Using 3G or higher SIM card
• WiFi: Wireless internet connection
• TCP/IP: Wired network connection with static or dynamic IP address

Cloud-Based Services: The module connects to TELEFIRE Connect services, enabling:

• Remote system supervision
• Real-time alarm and fault reporting
• Maintenance report generation
• System status monitoring

Simple Installation and Configuration: The MCOM-7L connects directly to the control panel’s COM1 or COM2 port via flat cable and requires 24VDC power supply.

Technical Specifications

• Power Supply: 24VDC (from control panel)
• Communication Interface: RS-232 (via COM1 or COM2 port)
• Supported Protocols: Cellular (3G+), WiFi, TCP/IP
• Baud Rate: 115,200
• TCP Port: 9 (in Bridge mode)
• Operating Temperature: -10°C to +60°C (assumed, according to 7000 series standard)

Installation Modes

Bridge Mode: Point-to-point static TCP/IP address connection
IOT-Net Mode: Static or dynamic IP address internet connection
IOT-WiFi Mode: Wireless internet connection
IOT-Cellular Mode: Cellular network connection with 3G+ SIM card

Installation and Configuration

Prerequisites:

• Control panel firmware must be version 5.66 or higher
• All power sources (mains and battery) must be disconnected before installation
• 3G+ SIM card required for cellular connection

Configuration: Done using TCS-7030 software MCOM Prog application, which allows:

• Customer ID and site data entry
• Communication mode selection
• Network settings configuration
• System architecture definition

Compatibility

Control Panels:

• ADR-7000 series
• SAVER-7000 series
• GUARD-7 series

Software Requirements:

• Control panel firmware: 5.66 or higher
• TCS-7030 programming software with MCOM Prog module